Then drag the blade in a straight line towards you.
Cut carpet straight line.
Keep the wrist fixed.
Next place the tip of a utility knife against the carpet backing and press until it pierces the backing.
A straight edge is going to be necessary to guide your knife along the edge of the carpet.
The base of the cutter is not straight which prevents it from accurately sliding along a guide.
While it is simple enough to cut carpet with a utility knife or carpet shears there are methods you can use to streamline the process and ensure that your cuts are efficient and clean rather than ragged and time consuming.
You may need to change the blade several times during a large carpet project.
When you cut carpet you need to make sure that you cut it straight.
To cut carpet for installation start by unrolling the carpet so that the backside is facing up.
Lay a straightedge along the chalk line and cut through the carpet with a carpet knife or utility knife using the straightedge as a guide for the knife.
Then crease the fold open the paper and fold in the opposite direction along the same crease.
Once the knife is chosen one must always drag the knife in a straight line in a slow smooth motion.
Sliding the rotary cutter along the straight edge will cut the material in a straight line.
Use sharp utility knife which is key to making a clean cut.
Here are a few tips for cutting carpet straight.
Draw a straight line.
The best way to cut carpet is by using a cutting guide.
One of the most important things that you will want to do is use a straight edge.
Be sure to cut down a single line of backing threads as you work.
You cannot do this using the worx cutter as the leading edge of its base must go under the fabric to get to the blade.
To cut a straight line without a ruler start by folding your piece of paper so the fold is where you want the cut to be.
Place a long straightedge down to draw a marker line on the back of the carpet where a straight cut is required and then keep the straightedge on that line as you make the cut.
A very uniform straight cutting line is essential to make the seam as invisible as possible.
A long metal straight edge is.
Use a straight edge.
