Install a plywood blade backward onto a circular saw.
Cutting vinyl lattice circular saw.
You should never go for a saw blade with large teeth capable of ripping and tearing.
You will find a special type of cutting blade specifically made to cut vinyl lattice.
It comes in a variety of designs but a diagonal weave is among the more traditional choices.
For plastic or solid core vinyl lattice you may want to use a vinyl cutting blade.
I had to replace a couple vinyl lattice sections that w.
Made from the same pvc or polyvinyl chloride as plumbing pipe it is molded to look like woven wood lattice.
Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade.
Use a power saw such as a circular saw or fine toothed hard saw to cut the panels to size.
The best tool for cutting plastic lattice is a circular saw with a plastic cutting blade.
Squeeze the saw s trigger and move the circular saw slowly along the full length of the marked line.
Mark the area to cut and slowly feed the blade into the siding.
The best saw blade for cutting vinyl lattice is one that has small straight teeth not teeth that are hooked or otherwise designed to rip and tear such as saw blades designed to cut through.
If necessary walk on the lattice to the side of the lumber opposite the saw and marked line.
Start by cutting your vinyl lattice.
Always use cutting blades which are sharp enough.
These include miter saws chop saws table saws and handheld circular saws.
Cutting pvc creates sharp saw shavings vinyl lattice is used for a number of things from arbors fence accents and deck or porch skirts.
Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line.
Ease the saw or blade carefully through the lattice.
A second option of blade you can use is a fine toothed blade a blade with small and straight teeth.
To cut the vinyl lattice you will need a circular saw and a cutting blade.
If you use a dull blade it will not provide you a good finished result.
This will enable you to cut through the staples in the panels with ease.
Position the saw so it s right along the pencil line then start making a careful straight cut down the lattice.
8 squeeze the saw s trigger and make a slow steady cut down the line.
This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you.
