If you don t have a vinyl cutting blade you can use another fine toothed blade.
Cutting vinyl lattice with hand saw.
Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line.
On the other hand if you need to cut the plastic lattice into angles and curves you should use a power saber saw.
Start by cutting your vinyl lattice.
If necessary walk on the lattice to the side of the lumber opposite the saw and marked line.
Have your helper assist you in guiding.
Adjust the blade depth on a circular saw by releasing the blade lever on the back.
Remove the t square guide and the rip fence.
Squeeze the saw s trigger and move the circular saw slowly along the full length of the marked line.
The width depth of the blade may offer a bit more straight.
To cut vinyl lattice attach a vinyl cutting blade to the power saw.
Pvc lattice can be cut with a hand saw circular saw table saw or just about any saw that cuts wood.
The best saw blade for cutting vinyl lattice is one that has small straight teeth not teeth that are hooked or otherwise designed to rip and tear such as saw blades designed to cut through.
If you plan to make angled or curved cuts use a power saber saw.
A fine blade back saw much like what s used in a miter box.
In case you have to do a lot of cutting in straight lines with the plastic lattice the circular saw or power saw with the plastic cutting blade is your best option.
If you have a helper a table saw is ideal.
The best way to cut vinyl lattice is to use a circular saw and a cutting blade.
Cut correctly be sure the lattice face side is upward when a fine toothed hard saw is in use.
Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade.
You can also use a trim saw or a handsaw.
Most of the people who usually need to do it regularly suggests using a circular saw and a sharp and new cutting blade.
Set the blade depth 0 5 in 1 3 cm wider than the lattice s thickness.
Some are sold without the support spine allowing no angleing as you cut.
This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you.
