Unisaw standard throat plate.
Delta table saw fence adjustment.
10 contractor table saw.
10 compound sliding miter saw.
Unisaw dado throat plate.
30 rail for t square fence.
Getting the correct measurement on a table saw.
Inspect the mechanism that makes the fence work and see if there s a nut you can tighten that will put more grab on the back part of the fence.
This is an important step in table saw alignment.
The rear clamp can often be tensioned independently of the front.
Explanation of how to do the tie bar alignment procedure on a delta contractor saw.
It is also most likely.
One grabs on the front rail and another grabs on the back.
I suspect your table saw fence has a two clamp system.
Delta table saw arbor wrench.